We all like to have our smartphone in perfect condition at all times. However, there are some parts of it that we neglect more than others. This is the USB connector that you connect to your device to charge it. This can cause a big headache if it stops working, but we may still be able to save it since if it only has some dirt inside, cleaning it is easier than you imagine.
That your phone does not charge when you attach the connector does not mean that it has been damaged. If it does not perform its function, it may be because the slot where you insert the connector is full of lint, which does not allow you to make the connection.
First of all, keep calm, do not rush and put anything in, you could damage the terminal permanently. If it is very difficult for you to insert the connector or, on the other hand, it is easily disconnected, it is more than likely that something is preventing the proper functioning of the system and that is why it is important that you know how to clean it .
Use something pointed
Keep in mind that we are going to introduce sharp objects into the connector so the first thing you should do is turn off your device, since if we are not careful we could create more severe internal damage than a simple lint. Wait a few minutes for it to turn off completely and get to work.
Now what you will need is a sharp object that is large enough for you to insert it. You can use a needle or a pin, even the skewer that we use to open the SD and SIM card compartment.
Very carefully
Once you have a valid object, it is time to act. The method is simple, but you must be very careful not to drive the spike crazy, as you could break the connector. The key is to do it smoothly and without puncturing, but as if we were dragging out.
Little by little you will see how the dust comes out and you may be surprised by the amount of fluff that was lodged in your mobile. This has no greater mystery. The most important thing is to be careful. If you plug in the connector and your device won’t charge, repeat the process one more time.
Compressed air
When we finish the procedure you can use a can of compressed air in the USB port of the phone . It is a much better option than blowing, which can lead to major failures. These are designed not to cause any damage to components (such as the speaker) when we clean them. In fact, it is often used a lot when cleaning a PC.
Before putting an air flash to your connector, make sure you are at the recommended distance so as not to print fully on your smartphone. We repeat that it is very important that you do not blow on your own, this is not a Nintendo cartridge. We no longer say it just because you don’t have the same force as the canister, which we can control, but because particles could get into the groove and cause a bigger problem.